The Masai Sliding Side Step
Sliding Side Step suitable as: a minibus side step, a taxi side step, caravan step, motor home step, horsebox side steps, coach side step, van side step, campervan step, ambulance side sliding step, etc.
The Masai Sliding Side Step width is 400mm, length is 600mm.
A high quality sliding side step made of aluminium and manufactured by Masai Omega Automotive. Sliding Side Step Fitting Instructions and Maintenance Tips provided. It has approval from the VCA (Vehicle Certification Agency) July 2011 – Click here to view the report; and it fully meets the requirements of the Large Bus Construction Directive 2001/85/EC regulation 107.02 up to and including supplement 5 ECE Regulation 107.03.
The Sliding Side Step maybe of interest to :
- Bus, minibus and taxi manufacturers
- Ambulance manufacturers
- Horsebox manufacturers and converters
- Van converters
- Taxi converters
- Campervan and motor home manufacturers and converters
- Or private individuals who are upgrading any of the above vehicles themselves.
[fvplayer src=”https://www.masai4x4.com/wp-content/uploads/Masai-side-sliding-step.mp4″ width=”460″]
Aluminium Roof Light Bar For Defenders 90, 110 and 130
Aluminium Roof Light Bar For Defenders 90, 110 and 130.
- Lights not included!
- NOTE: If you have a snorkel already fitted, please check they will fit together. This roof light bar will fit along with a genuine land rover snorkel, or our Masai Snorkel. If you own any other after-market snorkel please check the fitments.
- Roof Light Bar suitable for Land Rover Defender 90 and 110.
- Aerodynamic swept Aluminium profile.
- Black powder coated matt finish.
- 4 adjustable position light mounting brackets.
- Easy to fit DIY, clamp-on system – no drilling required.
- 150cm x 25cm x 15cm.
Fitting Tips
The design of this light bar enables 2 methods of fitting. There are two sets of holes in the light bar bracket. A set on the top (for use with method 1) and a set on the bottom (for use with method 2). The 2 sets of holes have not been designed to match with each other..
Method 1
The "clamp-on" systems uses a combination of a rubber block and securing bolts that secures the lightbar in place as the bolts are tightened. Due to the variance in gutter dimensions across different years and models, the rubber block may need to be cut with a Stanley Knife to fit.
Method 2
We recommend in cases where light bars are fitted with heavy lights, that a mechanical solution is applied to secure the light bar in place. This will require using the 2 holes on the bottom section of the light bar and drilling 2 holes into the gutter itself before securing with bolts (Not Supplied).
